Acrel

Однофазный счетчик энергии ADL200 на DIN-рейку

Счетчик энергии ADL200 на DIN-рейке принимает установку на DIN-рейку DIN35 мм с ЖК-дисплеем, он может измерять электрические параметры и имеет импульсный выход энергии, связь RS485, что имеет преимущества небольшого размера, высокой точности, хорошей надежности и удобной установки.

Получить предложение Связаться с нами

Быстрая и безопасная логистика
Образец доступен

АДЛ200 CE-ADL200 EAC-ADL200 МИД-АДЛ200

ADL200

Rated Voltage: AC220V

Rated Current: 10(80)A

RS485(MODBUS-RTU) Communication

LCD Display; 35mm DIN Rail Installation

Multi-tariff: 4 Tariff Rates (Spike, Peak, Valley and Flat kWh)

MID Certificated

Functions

Technical Parameters

Display

Dimension

Note：The torque of direct connect should not be greater than 4.0N·m.

Front Panel

① Enter-wire
② Brand
③ Panel
④ Up Button
⑤ Down Button
⑥ Pluse Output
⑦ Model
⑧ Set Button
⑨ Out-wire

Network

Installation

FAQ

Q:The display power or energy count is inaccurate after the meter powered on.

A:Switch the meter display interface to the power (active power P, power factor λ) interface, and check whether the power display is negative or not.And whether the power factor is between 0.9-0.95, and then check whether the incoming and outgoing wires of the current signal wire are connected reversely (that is, the current The incoming wire must be the same as the incoming wire end of the meter), and consistent with the wiring diagram on the meter.

Q:It cannot communicate with the host computer normally after the instrument powered on.

A:1. The voltage value between the communication output A and B of the measuring instrument should be between +(4.4-4.5)V .

2. Check whether the communication wiring method is correctly wired according to the wiring diagram (that is, the communication terminal A/B of the instrument must be connected with Corresponding to communication serial port A/B);